China Sealcon Company

Seal Transformation of Head Cylinder Body of Single Cartridge Cool Machine

1.Original sealing structure and sealing effect

The head of the cooling machine is originally used as a stone - tired seal structure. The results showed that the sealing effect was not satisfactory, and the graphite block slide slot could not slide flexibly due to thermal deformation and ash dust accumulation. The graphite block can not be well combined with the simplified body, and the head swing of the simplified body is large, which causes the local wear and damage of the graphite block, increasing the flow rate of the cooling machine and the discharge of the material ash, causing environmental pollution. Almost every month, the branch factory will send special personnel to repair and replace the graphite blocks, which increases the consumption and inspection fee of the graphite blocks. At the same time, it was found that local deformation and cracks occurred on the flange of the head of the cooler cylinder, which caused the hidden trouble of the equipment and affected the comprehensive operation rate of the rotary kiln.

2.The head of simplified body and mechanical sealing modification

When the kiln is repaired, the head and sealing device of the cooler are reformed. Due to the cracking and deformation of the end flange and cone part of the simplified end face, the end face of the cone of the flange is cut off 200m, the flange 5 is welded and the reinforced plate is fixed. To facilitate installation, the guard plate and the hopper are separately made, each with 30 pieces. Therefore, a guard plate 4 (material :ZG3Cr25N19512) is installed in the simplified body. At the same time, a semicircle sleeve is installed at the bottom of the connecting taper plate, which is used to connect the material ash of the side part of the feeding tray. It is allowed to enter the hopper and allow the ash to rotate to the top in the hopper and then return to the blanking pallet and return to the process.